Kitserver 6 速度调节模块 by juce

细亚俊秀

使用方法：
-Copy files speeder.dll i speeder.cfg into kitserver folder
-复制speeder.dll 和 speeder.cfg 两个文件到kitserver目录
-open file kload.cfg with notepad
-用记事本打开kload.cfg
and write DLL.num=13 (before was 12) i make new line down: DLL.12 = "kitserver\speeder.dll"
并将DLL.num=12改为DLL.num=13，并在DLL.11下一行写入DLL.12 = "kitserver\speeder.dll"
and save that file.
然后保存此文件。
- open speeder.cfg with notepad and changecount factor,1 is normal speed,lower than 1 is slower game speed,and upper is faster speed. (like 0,8 for slow or 1,5 for faster)
-用记事本打开speeder.cfg并修改参数count factor，1是正常速度，小于1降低速度，大于1提高速度。（例如0.8是慢速，1.5是高速）

It is not advised to use values lower than 0.7, because the music/commentary starts to break up. Also values larger than 2.5 are not supported. It is already ridiculously fast with 2.5!.
小于 0.7 值不允许使用，因为音乐/解说将被破坏。同样，大于 2.5 的值也不支持。超过 2.5 将会显得很搞笑!. .

下载地址：
[hide][/hide]